Programming the alarm (page 2 of 3)

At the end of the procedure if the LED: - FLASHES 6 times, this means that the code has been correctly programmed; - FLASHES 18 times, this means that the serial line between the receiver and the alarm is broken or that a previously programmed code has remained in the alarmmemory (failure to accept new code). If this should occur, proceed as described below.

If the programming button in the courtesy light is not pressed the ITALY operating mode will be recognized automatically if this operation is being carried out for the first time. If, on the other hand, this operation has already been carried out previously, then the system will arrange the mode already programmed.

NOTE In order to programme the country code and recognize the operating mode of the actual Country, use the following procedure.

1) - Open the bonnet lid; 2) - turn the ignition key from the ON position to the OFF position; 3) - within 15 seconds move on to the next operation; - press the bonnet lid button (A) 7 times in rapid succession;

This last manoeuvre should be carried out in less than 10 seconds.