Programming the alarm (page 3 of 3)

• 5 audible signals indicate the entry into MANUAL DIAGNOSIS;

4) - during these 5 audible signals press the bonnet lid switch (A) and keep it pressed;
- a last "beep" will signal that this manouevre has been accepted;

5) - keep the switch (A) pressed for the entire duration of the last "beep": this operation signals the entry into the Country programming state and consequently the possibility of entering the country code (see table on page 138);

• release switch A;
  - within the next 10 seconds press and release the switch following the instructions given in the table on page 138 (each time the button is pressed there will be an audible confirmation).

NOTE In order to programme the country code it is possible to use the procedure with the Fiat-Lancia Tester.