Programming codes with manual access

PROGRAMMING CODES WITH MANUAL ACCESS

From the moment the memory is "closed", the introduction of further remote control codes takes place by "manually opening the memory". This opening should be carried out following the instructions given in points 1 to 12 working in rapid succession.

Start of manual opening of the memory (entering a known password)

• The method for entering the password is as follows:

1. Press the button in the receiver for around 2 seconds: the LED should flash.

2. Release the button: after about 2 seconds the LED will flash briefly indicating that it is possible to introduce the first figure of the password.

5 impulses

3. Immediately press the button for the receiver as many times as indicated by the first digit of the password (for example: 5 times);
   it should be noted that for each impulse the LED will come on briefly to give a visual confirmation.