Programming the alarm password (page 2 of 2)

8. After about 2 seconds the LED will emit another flash to request the input of the last figure (the 3).

3 impulses 9. Immediately press the button for the receiver as many times as indicated by the last digit of the password (for example: 3 times); it should be noted that for each impulse the LED will come on briefly to give a visual confirmation.

After having entered the four figures of the password, the LED in the receiver should behave in the following way: a) it should start to flash for 10 secs if the password has been correctly entered (opening of the memory); b) it should come on constantly for 10 seconds to indicate that the password has not been correctly entered or that it does not correspond to any of the codes for the remote controls programmed. If this is the case, after the LED goes out, the correct password should be reintroduced starting from point 1.

10. Whilst the LED is flashing, press the button in the courtesy light and keep it pressed; the LED should continue to flash.