Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Croma Factory Service Manual (2005-2010)16 · Electrical equipment
16 · Electrical

Anti-theft devcie remote control operation check

Make
Fiat
Model
Croma Factory Service Manual
Year
2005–2010
Section
Special accessories › Anti-theft devcie remote control operation check
Electrical equipmentAnti-theft devcie remote control operation check

ANTI-THEFT DEVCIE REMOTE CONTROL OPERATION CHECK

Check 5580EA

The key remote control is supplied by a CR2032 lithium battery (3 V, 220 mAh), remote control operation is ensured between 2.6 and 3.6 V with a maximum current of 15 mA. At least 9000 activations of 1 s duration and 3000 activations of 5 s duration are guaranteed over a period of two years.

The battery voltage is monitored to check the charge level: the threshold is set at 2.6±0.06 V. If the remote control receiver detects that the battery is flat, it is still possible to carry out a total of 100 operations.

Operating frequency: 433.92 MHz.

1.8, 2.2

CHECK TO BE PERFORMEDRESOLUTION IF THE CHECK IS NOT OK
1

Take out the key battery and connect the diagnostic instrument in Voltmeter mode to the key terminals with the correct polarity.

Check that the voltage exceeds 2.2 Volts.

Replace the battery

All versions

CHECK TO BE PERFORMEDRESOLUTION IF THE CHECK IS NOT OK
1

Take out the key battery and connect the diagnostic instrument in Voltmeter mode to the key terminals with the correct polarity.

Check that the voltage exceeds 2.2 Volts.

Replace the battery

Note that after replacing the battery, the remote control variable code must be re-synchronised: this operation is carried out by pressing the remote control key twice.

Note that if the remote control has been activated more than 255 times, variable code synchrony between the sending unit and the receiver will be lost (the receiver will no longer be able to identify a variable code message correctly). Synchrony should therefore be restored by pressing the remote control unit key twice.

Parts & tools for this job For 2005 Fiat Croma

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.