4.2. Re-assembling (page 4 of 9)

Figure : B2CM04CD

Put into place the following tools :

• The expanding mandrel [13]
• The dial gauge support rod [14a]; Using the 2 nuts; Pinch the satellite carrier unit
• The dial gauge support rod [14c]
• The dial gauge support [14b]
• The dial gauge [15]

Rotate the assembly several times; Using tool [13].

Set the dial gauge to zero.

Take 4 measurements at ? 90? of the clearance operating tool [13] vertically.

CAUTION : Maximum axial play 0,1 mm; If the result of the measurement is above this value, replace the friction washer to obtain the correct clearance.

N.B. : The friction washers are available in 7 different thicknesses : 1,55; 1,60; 1,65; 1,70; 1,75; 1,80; 1,85 mm.

Remove the tools [13], [14a], [14b], [14c], [15].