19 · Transmission

4.2. Re-assembling (page 8 of 9)

Make: Fiat
Model: Ducato Mk3 (250) Factory Service Manual
Year: 2006–2017
Section: Components internal to the gearbox

19 Gearbox4.2. Re-assembling · page 8 of 9

Check the drag torque.

CAUTION : If the torque is above 15 daNm (no rotation of the checking tool), increase the clearance on the sun whee on which you read the lowest clearance during the adjustments.

A close-up photograph of a differential box assembly showing a large silver ring gear with twelve blue hexagonal securing bolts around its perimeter. A callout line points to one bolt labeled '4'. The assembly sits on a yellow support block.

Figure : B2CM045D

Refit : The 12 securing bolts (4) ( differential box).

Tightening method for the screws (4) :

Pre-tightening to 2,2 ± 0,1 daN.m
Angular tightening of 55 ± 1,5 °

‹ Prev Next ›

Parts & tools for this job For 2006 Fiat Ducato

TOOLTorque wrenchSearch: 3/8 inch torque wrench
TOOLSocket setSearch: socket set metric
BOOKHaynes manualSearch: Haynes manual Fiat Ducato

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.