1088c30 - thermostat unit - r+r

Fit the engine compartment guard and fix it using the bolts.

• See Op. 5540B10 L/h or r/h headlamp (one) - r+r
• See Op. 7055B42 Supplementary wheel arch (one) - r+r
• See Op. 4450B10 Front or rear wheel (one) - r+r
• Lower the vehicle.
• Connect the negative (-) battery terminal.

Refill the engine cooling system with coolant.

After fitting the water pump, wait at least 1 hour before filling with coolant.

• Remove the protective bodywork covers.
• Close the bonnet lid.
• Remove the car from the ramp.

1088C30 - THERMOSTAT UNIT - R+R

Removal

1108 | Euro 3

• Position the vehicle on the ramp.
• Open the bonnet.
• Fit the protective bodywork covers.
• Disconnect the battery negative (-) terminal.

• Undo the engine coolant reservoir cap.

1. Undo the bolts securing the engine compartment guard.
2. Remove the engine compartment guard.

1108 | Euro 3

1. Remove the lower coolant hose from the radiator and drain the fluid into a suitable container.

1108 | Euro 3

• Connect the lower coolant outlet hose to the radiator.
• See Op. 1048A28 Vacuum air circuit resonator pipe - r+r
• See Op. 5510C10 Ignition coil/s - r+r
• Undo the bolt securing the ignition coils mounting and remove it.

1. Remove the upper radiator hose from the thermostat unit.
2. Unscrew the bolts.
3. Remove the thermostat unit (3a) and gasket (3b).