Installation

Installation

1108 Euro 3

• Fit the upper radiator hose to the thermostat unit.
• Fit the upper radiator hose.
• Fit the lower radiator hose.
• Fit the engine compartment guard and fix it using the bolts.
• Fit the ignition coils mounting and fix it using the bolt.
• See Op. 5510C10 Ignition coil/s - r+r
• See Op. 1048A28 Vacuum air circuit resonator pipe - r+r
• Connect the negative (-) battery terminal.

• Refill the engine cooling system with coolant.

• Remove the protective bodywork covers.
• Close the bonnet lid.
• Remove the car from the ramp.

1088D26 - RIGID INTAKE PIPE TO WATER PUMP - R+R FOR VERSIONS WITH A/C

Removal

1108

• Position the vehicle on the ramp.
• Open the bonnet.

1108 Euro 3

• Fit the protective bodywork covers.
• Disconnect the battery negative (-) terminal.

• Undo the engine coolant reservoir cap.
• Raise the vehicle.

1. Undo the bolts securing the engine compartment guard.
2. Remove the engine compartment guard.

1. Remove the lower radiator hose and drain the coolant into a suitable container.