Installation
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Engine cooling (1108 Euro 3) › Installation
10 EngineInstallation
- Remove the hose from the coolant rigid inlet pipe to the water pump.
- Undo the bolt fixing the rigid pipe to the engine block.
- Remove the rigid pipe together with the seal.
Installation
Fit the rigid pipe with the seal in the water pump seating and tighten the bolt to torque.
| Mounting | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| - | Screw | COOLANT PUMP RIGID INLET PIPE | M6 | (Engine side) 1.0 |
- Fit the hose on the coolant rigid inlet pipe to the water pump.
- Fit the lower coolant outlet hose to the radiator.
- Fit the engine compartment guard and fix it using the bolts.
- Connect the negative (-) battery terminal.
| Description | Connector | |
|---|---|---|
| - | Battery | A1 |
Refill the engine cooling system with coolant.
| Type | Component | Description | Q.ty. | |
|---|---|---|---|---|
| - | Liquid | ENGINE COOLING CIRCUIT | Paraflu' 11 | 4.6 |
- Remove the protective bodywork covers.
- Close the bonnet lid.
- Remove the car from the ramp.
Parts & tools for this job For 1998 Fiat Seicento
- PARTEngine gasket setSearch: Fiat Seicento 1998 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.