10 EngineRefitting · page 2 of 2
(Cont. Op. 1056A92)
- Connect the starter motor electrical connection
| Name | Connector |
|---|
| Starter motor | A20 |
- Electrically connect the alternator
| Name | Connector |
|---|
| Alternator | A10 |
- Connect the idle actuator electrical connection
| Name | Connector |
|---|
| Idle actuator | N74 |
- Restore the electrical connection of the air temperature sensor
| Name | Connector |
|---|
| Air temperature sensor | K42 |
- Connect the throttle position sensor electrical connection
| Name | Connector |
|---|
| Throttle position sensor | K56 |
- Electrically connect the single-injector (SPI)
| Name | Connector |
|---|
| Single injector (SPI) | N71 |
- Connect the air conditioner compressor enable solenoid
| Name | Connector |
|---|
| Air conditioner compressor enable solenoid | L20 |
- Electrically connect the rev sensor
| Name | Connector |
|---|
| Rev sensor | K46 |
- Electrically connect the engine coolant temperature sender
| Name | Connector |
|---|
| Engine coolant temperature sender | K35 |
- Connect the ignition coils electrical connections
| Name | Connector |
|---|
| Ignition coil N° 1 (CYL. 1-4) | A30 |
| Ignition coil N° 2 (CYL. 2-3) | A30 |
- Assemble the coil protection and fasten with its nut.
- Electrically connect the engine oil pressure sensor (switch)
| Name | Connector |
|---|
| Engine oil pressure sensor (switch) | K30 |
- Connect the fuel vapours recovery solenoid valve electrical connection ( see Op. 1080E28 Fuel vapours passage ENABLE SOLENOID VALVE to intake - R.R.).
| Name | Connector |
|---|
| Fuel vapours recovery solenoid valve | L10 |
- Insert the injection system wiring bundle in the fastening strap.
- Complete with Op. 1048A10 COMPLETE AIR CLEANER - R+R.
- Connect the battery negative (-) and positive (+) terminals
- Remove the body protection cover.
- Close the engine compartment.
02 Engine
