Reassembly

Note: Before removing the steering wheel, mark its position in relation to the steering shaft.

Reassembly

• Re-position the horn contacts lockring and the steering wheel in the original position.
• Tighten the nut fastening the steering wheel to the specified torque

• Connect the electrical connection of the horn

• Complete with Op. 5580C18 MODULE for AIR BAG - R+R.
• Complete with Op. 7040A26 Steering column COVER - R+R.
• Connect the battery (+) and (-) terminals

• Close the engine compartment.

4110A14 - STEERING WHEEL - SPOKE DIRECTING - INCL. CHECKING & IF NECESSARY ADJUSTING FRONT WHEEL TOE-IN

• Set the car on a lift fitted with optical wheel geometry control equipment.
• Straighten the steering wheel perfectly and lock it in this position using a suitable tool.
• Raise the car.

1. Slacken the nuts locking the adjustable track rods.
2. Tighten or loosen the steering box rods to align the front wheels and obtain the specified toe-in value

Note: Toe-in must be measured with the tyres inflated to the specified pressure and with the vehicle in running order.

• Tighten the adjustable track rod locking nuts to the specified torque

• Lower the vehicle.
• Remove the steering wheel locking tool.
• Remove the car body from the car lift.