Refitting

(Op. 4110D20 continued)

Refitting

• Fit the electrical power steering device and fasten the screws and nuts.
• Connect the steering sensor and steering motor electrical connections.

• Fit the steering shaft joint on the steering unit pinion in the position in which is was removed and fit the joint fastening screw.

The screw of the steering shaft fastening part must slot into the groove on the steering box pinion.

• Torque the nuts and screws fastening the electrical steering device.

• Complete with Op. 4110A40 Steering shaft JOINTS - Locking screws.
• Fit the Fiat CODE system ring aerial on the ignition switch.
• Connect the ignition switch electrical connections.

• Complete with Op. 7040L40 FRONT DOOR FRAME FOOTBOARD (ONE), LH or RH, - R.R.
• Complete with Op. 5010C38 SIDE AIR VENT (ONE), LH or RH, ON DASHBOARD - R.R.
• Complete with Op. 7040A37 FUSE COVER ON DASHBOARD - R.R.
• Complete with Op. 7065C10 CLIMATE CONTROL SYSTEM PLATE - R.R.
• Complete with Op. 5560B10 ANALOGUE INSTRUMENT PANEL - R.R.
• Complete with Op. 5550A12 STEERING COLUMN STALKS complete - R+R. for versions with AIR BAG.

• Complete with Op. 4110A10 STEERING WHEEL - R.R. for replacements or checks.

or

• Complete with Op. 4110A11 STEERING WHEEL - R.R. for replacements or checks for versions with AIRBAG.
• Complete with Op. 5580C18 MODULE for AIR BAG - R+R.
• Complete with Op. 7040A26 STEERING COLUMN PANEL - R.R.
• Connect the battery (+) and (-) terminals.

• Close the engine compartment.

4110D40 - ELECTRICAL STEERING ECU - R.R.

Removal

• Open the engine compartment.
• Disconnect the battery terminal (-).

• Lift the lower dashboard cover, right-hand side.

1. Remove the diagnostic socket (1a) from the support on the ECU (1b).
2. Loosen the nut (2a) fastening the ECU earth (2b).

1. Disconnect the electrical steering ECU electrical connections.

(Cont.d.)