Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)07 · 41 Steering
07 · Steering & suspension

Refitting

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Steering control and linkage › Refitting
41 SteeringRefitting · page 1 of 2

( Op. 4110D40 continued)

NameConnector
1Electrical steering ECUM86
Diagram showing the electrical steering ECU with connectors attached to its side and bottom, indicated by callout lines.
  1. Loosen the nuts (1a) fastening the ECU guard (1b) and remove the guard.
Close-up diagram of the ECU guard being removed, with a callout line pointing to the nuts (1a).
  1. Loosen the nuts (1a) fastening the ECU (1b) and remove it.
Diagram showing the ECU mounted on its bracket, with callout lines indicating the nuts (1a) securing it.

Refitting

  • Fit the ECU on the bracket and fasten the nuts.
  • Fit the guard on the ECU and fasten the nuts.
  • Connect the electrical steering ECU electrical connections.
NameConnector
-Electrical steering ECUM86
  • Position the earth wire on the ECU bracket and fasten it with the nut.
NameConnector
-Electrical steering earthC14
  • Reposition the diagnostic socket in the support on the ECU.
NameConnector
-Electrical steering diagnostic socketR22
  • Reposition the lower dashboard panel, right-hand side.
  • Connect the battery (-) terminal.
NameConnector
-BatteryA1
  • Close the engine compartment.

4110D50 - ELECTRICAL STEERING WIRING HARNESS - R.R.

Removal

  • Open the engine compartment.
  • Perform Op. 5530B10 BATTERY - R.R.
  1. Fit the fuse group on the rear part of the battery frame.
Diagram showing the fuse group located on the battery frame in the engine compartment, with a callout line pointing to it.

(Continued)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.