Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)10 · 55 Electrical equipment
10 · Electrical

Refitting

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Current generation (1108) › Refitting
55 Electrical equipmentRefitting

(Op. 5530B22 continued)

  1. Remove the fastening screw and disconnect the earth terminal on the side member.
NameConnector
3Battery earthC1
Diagram showing battery earth cable connections with callout numbers 1, 2, 3, and 4.

Refitting

Check that the earth wire is not damaged. If required, perform the continuity checks.

  • Reposition the battery earth cable and close the fastening clip.
  • Connect the earth terminal on the side member.
  • Connect the negative battery terminal clamp and fasten the screw.

899

5530B26 - BATTERY-STARTER MOTOR WIRE
- R.R.

Removal

  1. Remove the cover from the panel (1a), remove the nut and connect the electric wire leading from the battery.
NameConnector
1BatteryA20A
Diagram showing positive battery terminal and starter motor connections with callout numbers 1a, 1b, 2a, and 2b.
  1. Remove the cap from the positive battery terminal.
  2. Remove the two screws (2a) and disconnect the electric wires (2b).
  3. Loosen the screw. Lift and remove the clamp with electric wire fastened to the positive battery terminal.
NameConnector
3BatteryA1A
Diagram showing battery terminal clamp and electric wire connections with callout numbers 1, 2a, 2b, and 3.

Refitting

  • Fit the clamp on the positive battery terminal and torque the fastening nut.
  • Reconnect the two electric wires to the starter motor positive terminal and screw the two fastening nuts.
  • Fit the cap on the positive battery terminal.
  • Reconnect the electric wire to the starter motor. Torque the fastening nut and fit the plastic cap.

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.