Workshop Manuals Factory service & repair Fiat
01 00 General information and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 27 Axle06 33 Braking system07 41 Steering08 44 Suspension and wheels09 50 Auxiliary units10 55 Electrical equipment11 70 Bodywork12 Diagnosis13 Tests14 Wiring diagrams
Fiat Seicento Factory Service Manual (1998-2010)12 · Diagnosis
12 · Diagnostics

B10 The engine does not start in any condition

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Starting › B10 The engine does not start in any condition
DiagnosisB10 The engine does not start in any condition · page 1 of 3

B10 The engine does not start in any condition

The engine does not start. When the ignition key is turned to MAR, the instruments light up, the starter motor runs but the engine does not start.

Preliminarily check:

  • - if the inertia switch has tripped
  • - if there is fuel in the tank
  • - that there is no water, fluid or dirt in the fuel tank
  • - if the spark plugs type is correct
  • - conditions of the spark plugs and respective wires
  • - air intake circuit intactness
  • - if the catalytic converter is clogged up
Step Validity Operation to be performed Test results
All OK Problems found Intervention
1 CHECK E.I. AND CODE FAULT WARNING LIGHTS

Turn the ignition key to MAR. Check the following:
– the “e.i. fault” warning light should come on for approximately 4 seconds and then switch off.
– the “CODE” warning light should come on for less than 1 second and then switch off.

Go to Step 2 The “E.I. fault” warning light lights up and stays on. See table K50
The “CODE” warning light lights up and stays on. See table K52
Both warning lights light up and stay on. See table K51
The “E.I. fault” warning light does not light up. See table K54
The “CODE” warning light does not light up. See table K55
Neither lights light up Restore instrument panel connections
2 CHECK WITH DIAGNOSTIC TOOL

Connect the diagnostic tool (Examiner or other tool) to the diagnostic socket. Check the following:
– no errors in the engine ECU
– all parameters are plausible

Go to Step 3 No dialogue with ECU Restore connection between engine ECU and diagnostic socket
(Wiring diagram: E5030 “PETROL ENGINE ELECTRONIC CONTROL”)
Detected error in ECU Continue as shown by the diagnostic tool

(Cont..)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.