Workshop Manuals Factory service & repair Fiat
01 00 General information and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 27 Axle06 33 Braking system07 41 Steering08 44 Suspension and wheels09 50 Auxiliary units10 55 Electrical equipment11 70 Bodywork12 Diagnosis13 Tests14 Wiring diagrams
Fiat Seicento Factory Service Manual (1998-2010)12 · Diagnosis
12 · Diagnostics

B11 The engine does not start easily when warm

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Starting › B11 The engine does not start easily when warm
DiagnosisB11 The engine does not start easily when warm · page 1 of 2

B11 The engine does not start easily when warm

The engine is warm, e.g. has just been stopped after running a long distance. It either does not start or can be started only after several attempts. When the ignition key is turned, the instruments light up correctly, the starter motor runs but the engine does not start.

Preliminarily check:
– the spark plug type is correct
– spark plug and respective cable conditions
– air intake circuit intactness

Step Validity Operation to be performed Test results
OK ⚠ 🔧
1 CHECK WITH DIAGNOSTIC TOOL
Connect the diagnostic tool (Examiner or other tool) to the diagnostic socket.
Check the following:
– no errors in the engine ECU
– all parameters are plausible
All OK
Go to Step 2
Problems found Intervention
No dialogue with the ECU Restore connection between engine ECU and diagnostic socket
(Wiring diagram: E5030 “PETROL ENGINE ELECTRONIC CONTROL”)
Error detected in the ECU Continue as shown by the diagnostic tool
2 ACTIVE TESTS WITH THE DIAGNOSTIC TOOL
Perform the following active tests with the diagnostic tool (Examiner or other tool):
– fuel fumes recirculation solenoid valve
– injector
All OK
Go to Step 3
Problems found Intervention
Injector fault Restore connection between solenoid valve and ECU,
(Wiring diagram: E5030 “PETROL ENGINE ELECTRONIC CONTROL”) or replace solenoid valve OP. PROCEDURE 1080E26
Injector fault Restore connection between injector and ECU, (Wiring diagram: E5030 “PETROL ENGINE ELECTRONIC CONTROL”) or replace injector OP. PROCEDURE 1056A70

(Cont..)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.