Discovery II
SCREENS
76-4-4
REPAIRS
15. Apply a continuous bead of sealant to sealant
face on screen as shown.
16. With assistance, lift screen into place and align
to screen supports and tape. Ensure top
finisher is located into correct position. Lightly
press glass to fully seat sealer.
CAUTION: Do not apply heavy pressure to
the sides of the windscreen. Lightly press
windscreen from centre outwards until
edges are to required gap. Pushing sides
into position can bend windscreen and lead
to cracking in service.
17. Remove protective covers and tape.
18. Test sealer for leaks, apply additional sealer if
necessary. If water is used, allow sealer to dry
before testing. Spray water around glass and
check for leaks. Mark any area that leaks. Dry
glass and sealer then apply additional sealer.
19. Fit interior mirror to slug.
20. If applicable, connect screen heater multiplugs.
21. Fit air intake plenum.
CAUTION: A curing time of 6 hours is
desirable. During this time leave a window
open to ventilate the vehicle interior. If the
vehicle must be used before the curing time
has elapsed, do not drive at speed or slam
the doors with the windows closed.
CAUTION: Vehicles fitted with a passenger
airbag should not be driven for 24 hours.
Glass - body side - rear
$% 76.81.18
Introduction
The following equipment is required:
l
Cutting wire and handles.
l
Kent cutting knife.
l
Glazing knife.
l
Windscreen repair kit.
l
Sealant applicator gun.
l
Suction cups.
l
A felt covered table or stand to support glass.
WARNING: Wear protective gloves when
handling glass, solvents and primers.
WARNING: Wear suitable eye protection when
removing and refitting glass.
Remove
1. If fitted, disconnect coaxial cable from terminal
on glass.
2. Fit protection to exterior body work adjacent to
glass.
3. Cover body panels adjacent to glass.
4. Fit protection to internal trim adjacent to glass.
5. Cover interior of vehicle with protective sheet.