Models without air conditioning

30. Remove PAS pump.
31. Remove clip securing fluid feed hose to PAS pump.
32. Remove feed hose from PAS pump.

Refit

1. Fit fluid feed hose to PAS pump and secure hose with clip.
2. Clean mating face of PAS pump and coolant pump housing.
3. Align drive coupling and fit PAS pump to coolant pump.
4. Fit support bracket and tighten bolts securing pump and bracket to 25 Nm.
5. Lubricate and fit NEW ’O’ ring to high pressure pipe.
6. Connect high pressure pipe to PAS pump, but do not tighten at this stage.
7. Connect fluid feed hose to reservoir and secure with clip.
8. Tighten high pressure pipe to PAS pump union to 25 Nm.
9. Ensure pulley and mating face is clean.
10. Fit PAS pump pulley and tighten screws.
11. Fit auxiliary drive belt. See ELECTRICAL, Repairs.
12. Tighten PAS pump pulley screws to 9 Nm.

Models without air conditioning

13. Raise engine on jack to align to mounting bracket.
14. Fit bolts securing engine to mounting bracket and tighten to 120 Nm.

Models with air conditioning

15. Lower engine on jack to fit engine mounting.
16. Fit engine mounting bracket and tighten bolts securing bracket to engine to 80 Nm.
17. Fit upper tie bar to engine mounting bracket and tighten both bolts securing tie bar to 120 Nm.
18. Fit PAS hose bracket to engine mounting stud and tighten nut to 80 Nm.
19. Fit clamps to PAS hoses and fit nut and bolt securing hose clamp to bracket.
20. Fit air conditioning hose clip to PAS hose support bracket and secure with bolt.

All Models

21. Connect PAS fluid feed hose to reservoir and secure with clip.
22. Fit underbelly panel. See BODY, Exterior fittings.
23. Fit engine acoustic cover. See ENGINE - ’L’ SERIES, Repairs.
24. Bleed PAS system. See Adjustments.