Range Rover Classic
REAR SUSPENSION
7
REPAIR
ANTI-ROLL BAR REAR
Service repair no - 64.35.08
KEY
1. Anti-roll[sway] bar
2. Rubber bush
3. Strap
4. Nut, bolt, washer
5. Nut and washer
6. Ball joint link arm
7. Bolt and washer
8. Castellated nut and cotter pin
Remove
1. Note for reassembly, position of rubber bushes
on anti-roll[sway] bar.
2. Remove four nuts, bolts and washers securing
two bush straps.
3. Remove nuts, bolts, washers and rubber bushes
from the ball joint links and remove
anti-roll[sway] bar.
Refit
4. Position rubber bushes on anti-roll[sway] bar. Fit
joint in bush towards axle.
5. Fit anti-roll[sway] bar with two straps. Ensure ball
joint link arms point down as shown. Loosely fit,
bolts, washers and new Nyloc nuts.
6. Fit bolt, washers and rubber bushes. Fit
anti-roll[sway] bar to ball joint links. Tighten to
68Nm
7. Tighten nuts securing straps to
30Nm.