Range Rover Classic
ELECTRICAL
1
SPECIFICATIONS, TORQUE
TORQUE VALUES
NOTE: Torque wrenches should be regularly checked for accuracy to ensure that all fixings are
tightened to the correct torque.
Nm
A.C. generator to mounting bracket
24
...........................................................
A.C. generator module screws
1.2
...................................................................
Amplifier heat sink screws
1.2
.........................................................................
Auxiliary driving lamp mounting bolts
15
.........................................................
Distributor clampbolt
20
..................................................................................
Distributor pick-up bearing plate support pillars
1.2
.........................................
Distributor pick-up barrel nuts
1.2
....................................................................
Distributor vacuum unit
2
...............................................................................
Starter motor to engine bolts - V8i engine
45
..................................................
Reverse light switch
25
...................................................................................
Wiper motor yoke retaining bolts
1.5
...............................................................
Torque values below cover all screws and bolts used, unless specified otherwise.
METRIC
Nm
M5
6
......................................................................................................
M6
9
......................................................................................................
M8
25
.....................................................................................................
M10
45
...................................................................................................
M12
90
...................................................................................................
M14
105
..................................................................................................
M16
180
..................................................................................................
UNC / UNF
1/4
9
......................................................................................................
5/16
24
...................................................................................................
3/8
39
.....................................................................................................
7/16
78
...................................................................................................
1/2
90
.....................................................................................................
5/8
136
....................................................................................................