Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Oil pressure inspection [lf] (page 2 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Lubrication
EngineOil pressure inspection [lf] · page 2 of 3

on safety stands.

  • Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.
  1. Remove the battery cover.
  2. Disconnect the negative battery cable.
  3. Remove the oil pressure switch.
  4. Screw the SSTs into the oil pressure switch installation hole.
  5. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  6. Warm up the engine to normal operating temperature.
  7. Run the engine at the specified speed, and note the gauge readings.
    • If not within the specification, inspect for the cause and repair or replace if necessary.

NOTE: The oil pressure can vary with oil viscosity and temperature.

ENGINE – Lubrication [LF] – figure
Fig. 3: Screwing SST Into Oil Pressure Switch Installation Hole
Courtesy of MAZDA MOTORS CORP.

Oil pressure (reference value) [oil temperature: 100°C {212°F}]

337-591 kPa {3.44-6.03 kgf/cm2 , 49.0-85.8 psi} min [3,000 rpm]

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.