Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Oil pressure inspection [lf] (page 3 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Lubrication
EngineOil pressure inspection [lf] · page 3 of 3
  1. Stop the engine and wait until it is cool.
  2. Disconnect the negative battery cable.
  3. Remove the SSTs.

CAUTION: Make sure that there is no sealant between 1.0-2.0 mm {0.04- 0.07 in} from the end of the oil pressure switch to prevent a possible operation malfunction.

  1. Apply silicone sealant to the oil pressure switch threads as shown in Fig. 4 .
  2. Install the oil pressure switch.

Tightening torque

12-18 N.m {1.3-1.8 kgf.m, 9-13 ft.lbf}

  1. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  2. Install the battery cover.
  3. Start the engine and confirm that there is no oil leakage.
    • If there is oil leakage, repair or replace the applicable part.
ENGINE – Lubrication [LF] – figure
Fig. 4: Applying Silicone Sealant To Oil Pressure Switch Threads

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.