Workshop Manuals Factory service & repair Rover
Rover 200 Workshop Manual (1995-1999)10 · Engine management system - MEMS
10 · Engine

Fuel injectors - ’K8’

Make
Rover
Model
200 Workshop Manual
Year
1995–1999
Section
Repairs › Fuel injectors - ’K8’
Engine management system - MEMSFuel injectors - ’K8’

FUEL INJECTORS - ’K8’

Service repair no - 19.60.12

Remove

  1. Disconnect battery earth lead.
  2. Remove fuel rail. See this section.
Fuel injectors - ’k8’ – Remove fuel rail. See this section.
  1. Disconnect multiplugs from injectors.
  2. Remove injectors from inlet manifold.
  3. Remove and discard ’O’ rings from injectors.
  4. Fit protective caps to each end of injectors.

Refit

  1. Clean injectors and recesses in inlet manifold.
  2. Lubricate new ’O’ rings with silicone grease and fit to injectors.
  3. Fit injectors to inlet manifold.
  4. Connect multiplugs to injectors.
  5. Fit fuel rail. See this section.
  6. Connect battery earth lead.

FUEL INJECTORS - ’K16’

Service repair no - 19.60.12

Remove

  1. Disconnect battery earth lead.
  2. Remove fuel rail. See this section.
Fuel injectors - ’k16’ – Remove fuel rail. See this section.
  1. Disconnect multiplugs from injectors.
  2. Remove injectors.
  3. Remove and discard ’O’ rings from injectors.
  4. Fit protective caps to each end of injectors.

Refit

  1. Clean injectors and recesses in inlet manifold.
  2. Lubricate new ’O’ ring seals with silicone grease and fit to injectors.
  3. Fit injectors to inlet manifold.
  4. Connect multiplugs to injectors.
  5. Fit fuel rail. See this section.
  6. Connect battery earth lead.

Parts & tools for this job For 1995 Rover 200

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.