Workshop Manuals Factory service & repair Rover
Rover 200 Workshop Manual (1995-1999)17 · Manual gearbox - R65
17 · Transmission

Gear selector mounting

Make
Rover
Model
200 Workshop Manual
Year
1995–1999
Section
Repairs › Gear selector mounting
Manual gearbox - R65Gear selector mounting · page 1 of 5

GEAR SELECTOR MOUNTING

Service repair no - 37.16.25

Remove

  1. Raise front of vehicle.

WARNING: Support on safety stands.

Gear selector mounting – Raise front of vehicle.
  1. Remove 2 bolts securing mounting to body.
  2. Remove mounting plate and rubber from gear selector.

Refit

  1. Position mounting rubber and plate, fit and tighten bolts to 22 Nm.
  2. Remove stand(s) and lower vehicle.

MANUAL GEARBOX - ’K8’

Service repair no - 37.20.02.99

Remove

  1. Raise front of vehicle.

WARNING: Support on safety stands.

  1. Remove vehicle speed sensor. See INSTRUMENTS, Repairs.
  2. Remove starter motor. See ELECTRICAL, Repairs.
  3. Remove ECM. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
  4. Remove engine management relay module. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
Manual gearbox - ’k8’ – Remove engine management relay module. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
  1. Remove 2 bolts securing resonator to battery tray.
  2. Remove resonator.

Parts & tools for this job For 1995 Rover 200

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.