2.

2.

The ABS indicator light remains ON after the engine is started, however the ABS indicator light does not blink any DTC. Check the following items:

• Loose or poor connection of the wire harness at the ABS control unit.
• Faulty ABS B2 (15 A) fuse in the under-hood ABS fuse/relay box.
• Open circuit in WHT wire between the ABS B2 (15 A) fuse in the under-hood ABS fuse/relay box and ABS control unit.
• Open circuit in YEL/BLK wire between the No. 7 HEATER CONTROL RELAY, REAR DEFROSTER RELAY (7.5 A) fuse in the under-dash fuse/relay box and ABS control unit.
• Short circuit in BLU/RED wire between gauge assembly and ABS control unit.
• Open circuit in WHT/BLU wire between alternator and ABS control unit.

If the problem is not found, substitute a known-good ABS control unit and recheck whether the ABS indicator light remains ON.