32. Remove the exhaust pipe. (page 5 of 9)

1. Install the engine in the reverse order of removal.

Note: After the engine is in place:

• Torque the engine mount bolts/nuts in the sequence shown.

CAUTION: Failure to tighten the bolts/nuts in the proper sequence can cause excessive noise and vibration, and reduce bushes life; check that the bushes are not twisted or off-set.

• Check that the spring clip on the end of each driveshaft clicks in place.

CAUTION: Install new spring clips.

• Bleed air from the cooling system at the bleed bolt with the heater valve open.
• Adjust the throttle cable tension.
• Check the clutch pedal freeplay (M/T).
• Check that the gearbox shifts into gear smoothly.