32. Remove the exhaust pipe. (page 7 of 9)
- Make
- Rover
- Model
- 600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
- Section
- Engine remove: repairs
Engine32. Remove the exhaust pipe. · page 7 of 9
- Adjust the tension of the following drive belts:
Alternator belt, see ELECTRICAL.
Power steering pump belt, see STEERING.
Air conditioning compressor belt, see HEATING & VENTILATION. - Clean battery posts and cable terminals with sandpaper, assemble, the apply grease to prevent corrosion.
- Inspect for fuel linkage.
After connecting all fuel line parts, turn on the ignition switch (do not operate the starter) so that the fuel pump operates for approximately two seconds and the fuel line is pressurised. Repeat this operation two or three times and check whether any fuel leakage has occurred at any point in the fuel line.
Parts & tools for this job For Rover 600
- PARTExhaust gasketSearch: Rover 600 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.