32.INSTALL CLUTCH HOUSING - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REASSEMBLY › 32.INSTALL CLUTCH HOUSING - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
32.INSTALL CLUTCH HOUSING
c.

Install the front bearing retainer to the front transmission case with new 11 bolts. Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)
CAUTION: Since the manual transmission unit is very heavy, perform these procedures with 2 people.
31111
32.INSTALL CLUTCH HOUSING
a.

Install the clutch housing to the manual transmission case sub-assembly with the 10 bolts. Torque: 36 N*m (367 kgf*cm, 27 ft.*lbf)
CAUTION: Since the manual transmission unit is very heavy, perform these procedures with 2 people.
33321G
33.TIGHTEN MANUAL TRANSMISSION OUTPUT SHAFT REAR SET NUT
CAUTION: Since the manual transmission unit is very heavy, perform these procedures with 2 people.
Parts & tools for this job For Toyota Hilux
- PARTClutch kitSearch: Toyota Hilux clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Toyota Hilux manual gearbox oil
As an Amazon Associate we earn from qualifying purchases.