Coolant Temp. - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- Coolant Temp. - Toyota Hilux Generation 7 2005-2010 Workshop Manual
Coolant Temp.
ES–180
1GR-FE ENGINE CONTROL SYSTEM – SFI SYSTEM

14
CHECK VALVE TIMING
(a) Remove the cylinder head cover. RH Bank Timing Marks (b) Turn the crankshaft pulley, and align its groove with the timing mark "0" of the timing chain cover. (c) Check that the timing marks of the camshaft timing gears are aligned with the timing marks of the bearing cap as shown in the illustration. If not, turn the crankshaft 1 revolution (360°) and align the marks as above. OK: ES Timing marks on camshaft timing gears are aligned as shown in illustration. Timing Marks LH Bank (d) Reinstall the cylinder head cover. NG

ADJUST VALVE TIMING
Timing Marks G036290E03
15
CHECK FUEL PRESSURE
(a) Check the fuel pressure (See page FU-6). NG
CHECK AND REPLACE FUEL PUMP,
PRESSURE REGULATOR, FUEL PIPE LINE
AND FILTER
16
READ VALUE OF INTELLIGENT TESTER (COOLANT TEMP)
(a) Connect an intelligent tester to the DLC3. (b) Turn the ignition switch ON. (c) Turn the tester ON. (d) Select the following menu items: DIAGNOSIS /
ENHANCED OBD II / DATA LIST / PRIMARY /
COOLANT TEMP.
(e) Read the COOLANT TEMP twice, when the engine is both cold and warmed up. Standard: With cold engine: Same as ambient air temperature. With warm engine: Between 80°C and 100°C (176°F and 212°F).
Parts & tools for this job For Toyota Hilux
- FLUIDCoolantSearch: Toyota coolant antifreeze
- PARTThermostatSearch: Toyota Hilux thermostat
- TOOLCooling system pressure testerSearch: cooling system pressure tester
As an Amazon Associate we earn from qualifying purchases.