Readiness Tests. - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- Readiness Tests. - Toyota Hilux Generation 7 2005-2010 Workshop Manual
Readiness Tests.
ES–140
2TR-FE ENGINE CONTROL SYSTEM – SFI SYSTEM

CONFIRMATION DRIVING PATTERN
HINT:
• This confirmation driving pattern is used in the "PERFORM CONFIRMATION DRIVING PATTERN" procedure of the following diagnostic troubleshooting procedure.
• Performing this confirmation pattern will activate the Heated Oxygen (HO2) sensor monitor. (The catalyst monitor is performed simultaneously.) This is very useful for verifying the completion of a repair.
NOTICE: Vehicle Speed This test will not be completed if the vehicle is driven under absolutely Between constant speed, such as with cruise (h) 40 and 70 mph control activated. (64 and 113 km/h ) ES
Idling (g) Ignition Switch ON Time Warm up 10 minutes (Note: Even when vehicle stops during pattern, test can be resumed.) A115372E07
A116412 (a) Connect an intelligent tester to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the tester or scan tool ON. (d) Clear DTCs (where set) (See page ES-40). (e) If using an intelligent tester, select the following menu items: DIAGNOSIS / CARB OBD II /
READINESS TESTS.
(f) Check that O2S EVAL is INCMPL (incomplete). (g) Start the engine and warm it up. (h) Drive the vehicle at between 40 mph and 70 mph (64 km/h and 113 km/h) for at least 10 minutes.
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.