Switch - Ecm) - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- Switch - Ecm) - Toyota Hilux Generation 7 2005-2010 Workshop Manual
Switch - Ecm)
ES–433
2TR-FE ENGINE CONTROL SYSTEM – SFI SYSTEM

4
CHECK FUSE (AM2 AND IGN)
(a) Check the AM2 fuse. (1) Remove the AM2 fuse from the engine room R/B. Engine Room R/B: (2) Check the AM2 fuse resistance. Standard Resistance: Below 1 Ω (3) Reinstall the AM2 fuse. (b) Check the IGN fuse. (1) Remove the IGN fuse from the driver side J/B. (2) Check the IGN fuse resistance. Standard Resistance: AM2 Fuse Below 1 Ω ES Driver Side J/B: (3) Reinstall the IGN fuse. IGN Fuse NG


CHECK FOR SHORT IN ALL HARNESS AND
COMPONENTS CONNECTED TO FUSE
A115876E01
5
INSPECT IGNITION OR STARTER SWITCH ASSEMBLY
(a) Disconnect the I7 ignition switch connector. Component Side: Ignition Switch (b) Check the resistance. Standard Resistance Ignition Switch Tester Connections Specified Conditions Positions 4 3 2 1 10 kΩ or higher LOCK All Terminals 8 7 6 5 Below 1 Ω ACC 2-4 Below 1 Ω ON 1-4, 1-6, 2-4, 3-4, 5-6 Below 1 Ω START 1-4, 3-4, 5-6, 5-7 G037118E01 (c) Reconnect the ignition switch connector. NG

REPLACE IGNITION OR STARTER SWITCH
ASSEMBLY
CHECK AND REPAIR HARNESS AND CONNECTOR (BATTERY - IGNITION SWITCH, IGNITION
SWITCH - ECM)
Parts & tools for this job For Toyota Hilux
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.