Spd / Off. - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- Spd / Off. - Toyota Hilux Generation 7 2005-2010 Workshop Manual
Spd / Off.
FU–7
1GR-FE FUEL – FUEL SYSTEM

(g) Install SST and the fuel tube connector onto the vehicle. SST (Clip) SST 09268-41048 (90467-13001, 95336-08070, SST (Gauge) 09268-41500), 09268-45014 (09268-41200, 09268-41220, 09268-41250) (h) Wipe off any spilt gasoline. SST (T-joint) (i) Connect the cable to the battery negative terminal. Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) Fuel Tube

SST (Hose)
SST
Fuel Tube Connector SST (Hose) FU A065093E01 (j) Connect the intelligent tester to the DLC3. Intelligent (k) Turn the ignition switch to ON. Tester (l) Turn the intelligent tester ON. (m) Select the following menu items: DIAGNOSIS / ENHANCED OBD ll / ACTIVE TEST / FUEL PUMP / SPD / ON. (n) Measure the fuel pressure. Standard: DLC3

CAN VIM
281 to 287 kPa (2.87 to 2.93 kgf/cm2, 40.8 to
41.7 psi) G035612E02
• If the fuel pressure is greater than the standard value, replace the fuel pump.
• If the fuel pressure is less than the standard value, check the connection between the fuel hose and fuel pump. (o) Select the following menu items: DIAGNOSIS / ENHANCED OBD ll / ACTIVE TEST / FUEL PUMP /
SPD / OFF.
(p) Check that the fuel pressure does not change for 5 minutes. Standard: 147 kPa (1.5 kgf/cm2, 21 psi) If the result is not as specified, check the fuel pump and fuel injector. (q) Disconnect the intelligent tester from the DLC3. (r) Disconnect the cable from the battery negative terminal. (s) Remove SST and the fuel tube connector while being careful to prevent gasoline splashes. (t) Connect the fuel tube.
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.