With Rectifier - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- With Rectifier - Toyota Hilux Generation 7 2005-2010 Workshop Manual
With Rectifier
CH–18 1GR-FE CHARGING – GENERATOR (for BOSCH Made) If the diameter is less than the minimum, replace the generator rotor.

2.
INSPECT STATOR SUB-ASSEMBLY GENERATOR
WITH RECTIFIER
HINT: For terminal positions of the stator generator, refer to the illustration below.

Positive (+) Terminal Negative (-) Terminal Rectifier Terminal A095745E01 (a) Inspect the positive (+) rectifier.

HINT: Inspect the positive terminal after pulling it up. (1) Using an ohmmeter, connect the positive (+) tester probe to the positive (+) terminal and the negative (-) tester probe to each rectifier terminal. (2) Measure the resistance between the positive (+) terminal and rectifier terminal. Standard: A095746E01 Below 1 Ω If the result is not as specified, replace the stator generator. (3) Reverse the polarity of the tester probes and repeat step (1). (4) Measure the resistance between the positive (+) terminal and rectifier terminal. Standard: 10 kΩ or higher If the result is not as specified, replace the stator generator. (b) Inspect the negative (-) rectifier. (1) Using an ohmmeter, connect the positive (+) Ohmmeter tester probe to each negative (-) terminal and the negative (-) tester prove to each rectifier terminal. (2) Measure the resistance between the negative CH (-) terminal and rectifier terminal. Standard: 10 kΩ or higher If the result is not as specified, replace the G036165E01 stator generator. (3) Reverse the polarity of the tester probes and repeat step (1).

Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.