Rear wheels lock whilst braking
- Make
- Fiat
- Model
- 500 Factory Service Manual
- Year
- 2007–2024
- Section
- Brakes › Rear wheels lock whilst braking
REAR WHEELS LOCK WHILST BRAKING
When the brakes are operated the distribution between the front and rear wheels is not correct: in extreme conditions the rear wheels lock and the vehicle may skid
| Test results | ||||
| 0 | PRELIMINARY CHECKS | All OK | Problems encountered | Operation |
|---|---|---|---|---|
| First of all check whether the ABS warning light and the handbrake warning light come on simultaneously during starting and then go out. | Move on to Step 1 | The two warning lights both remain on after starting. | Proceed as instructed in the | |
| 1 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
Connect the Examiner diagnostic equipment to the diagnostic socket. Check that there are no faults in the ABS control unit. | Move on to Step 2 | 1. Error detected in the control unit. 2. No communication with the control unit. | 1. Continue following the instructions on the diagnostic equipment 2. Restore:
| |
| 2 | ACTIVE DIAGNOSIS WITH DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
Keeping the Examiner diagnostic equipment connected carry out the active diagnosis of:
| Move on to Step 3 for 1.4 16v version Move on to Step 4 for the 1.2 8v and 1.3 Mjet 16v versions | Fault detected in one of the solenoid valves. | Replace the electrohydraulic unit - ABS electronic control unit Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT - R.R. | |
| 3 | REAR BRAKE CALIPER CHECK | All OK | Problems encountered | Operation |
| Check the condition of the rear brake caliper pistons. | Move on to Step 6 | Pistons worn or seized. | Replace the rear brake callipers Op. 3310B34 | |
| 4 | REAR BRAKE CHECK | All OK | Problems encountered | Operation |
| Check the condition of the rear brake shoes. | Move on to Step 5 | Rear brake shoes worn | Replace the rear brake shoes Op. 3320B10 REAR DRUM BRAKES - R.R. | |
| 5 | CHECK THE SELF-ADJUSTING PLAY TAKE-UP DEVICE BETWEEN THE SHOES AND THE DRUM | All OK | Problems encountered | Operation |
| Check efficiency of the self-adjusting play take-up device between the shoes and drum. | Move on to Step 6 | Fault in the play take-up device. | Replace the micrometric recovery device. | |
| 6 | FAM ADJUSTMENT CHECK | All OK | Problems encountered | Operation |
| Check whether the device is preloaded with the handbrake in the rest position. | Move on to Step 7 | The device is preloaded with the handbrake in the rest position. | Restore the correct handbrake adjustment. | |
| 7 | FLEXIBLE BRAKE PIPES AND BLEEDING CHECK | All OK | Problems encountered | Operation |
Visually check for kinks or restrictions in the brake pipes. Bleed the system Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR and check that fluid emerges evenly from the bleed screws. | Move on to Step 8 | Bends or constrictions present, the fluid does not come out evenly. | Replace the section of pipe affected by the problem. | |
| 8 | FRONT BRAKE STATE CHECK | All OK | Problems encountered | Operation |
| Visually inspect that there is no grease, oil or dirt on the front braking surfaces. | End of diagnosis | Braking surfaces dirty. | Clean again, check and remove the causes of the fault: if necessary, replace the front pads | |
Parts & tools for this job For 2007 Fiat 500
- PARTBrake padsSearch: Fiat 500 2007 brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.