Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat 500 Factory Service Manual (2007-2024)14 · Suspension and wheels
14 · Steering & suspension

Rear suspension bush clearance check

Make
Fiat
Model
500 Factory Service Manual
Year
2007–2024
Section
Rear suspension › Rear suspension bush clearance check
Suspension and wheelsRear suspension bush clearance check

REAR SUSPENSION BUSH CLEARANCE CHECK

Check 4420DA

1.2 8v, 1.3 Multijet, 1.4 16v

With the vehicle on the ground, get underneath the vehicle on a trolley and check that the clearance for the rear bushes is sufficient and that there are no signs of contact or rubbing on the inner side of the vehicle.

From the outer side of the vehicle, the rear bushes are normally in contact, as designed, as shown in fig. 1

REAR SUSPENSION BUSH CLEARANCE CHECK

Parts & tools for this job For 2007 Fiat 500

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.