REAR SUSPENSION AXLE/CROSSMEMBER BUSHES - R.R.

Operation 4420D48 · REAR SUSPENSION AXLE/CROSSMEMBER

1.2 8v, 1.3 Multijet, 1.4 16v

Removing

- Position the vehicle on a lift.

- Disconnect the negative battery terminal.

Op. 7040L20 TUNNEL COVER - R.R

Op. 4450B08 RIGHT REAR WHEEL - R.R

Op. 4450B06 LEFT REAR WHEEL - R.R

Op. 4420D10 REAR SUSPENSION AXLE - R+R INCLUDES BLEEDING

- Remove both rear suspension axle supports.

Op. 4420D30 REAR SUSPENSION AXLE AXLE SUPPORT, LEFT OR RIGHT - R.R.

1. Position the special tool and extract the bush.

- Proceed in the same way for the opposite axle bush.

- Keep the special tool.

Refitting

- Position a new bush and check the alignment.

Use soapy water to facilitate fitting the bush in place.

1. Position the special tool (1a) and fit the bush (1b) in place.

- Proceed in the same way for the opposite axle bush.

- Keep the special tool.

- Fit both rear suspension axle supports.

Op. 4420D30 REAR SUSPENSION AXLE AXLE SUPPORT, LEFT OR RIGHT - R.R.

Op. 4420D10 REAR SUSPENSION AXLE - R+R INCLUDES BLEEDING

Op. 4450B08 RIGHT REAR WHEEL - R.R

Op. 4450B06 LEFT REAR WHEEL - R.R

Op. 7040L20 TUNNEL COVER - R.R

- Connect the negative battery terminal.

- Remove the vehicle from the lift.