Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)04 · 21 Gearbox and differential
04 · Transmission

Removing-refitting (page 3 of 9)

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Removing-refitting (Automatic)
21 Gearbox and differentialRemoving-refitting · page 3 of 9
Diagram showing the gear change control cable mounting bracket secured by nuts, indicated by arrows.
Diagram showing an earth cable connection point on the gearbox, indicated by an arrow.
Diagram showing electrical connectors for the selector lever position sensor and solenoids, with a corrugated conduit.
  1. Remove the nuts securing the gear change control cable mounting bracket, and move it over to one side.
  2. Disconnect the earth cable shown in the figure, from the gearbox.
  3. Disconnect the connectors shown in the figure of the selector lever position sensor and solenoids (gear change, lock-up clutch control and pressure control) after releasing them from the retaining clips.
  4. Disconnect the connector shown in the figure.
  5. Disconnect the speedometer drive cable.
Diagram showing a disconnected electrical connector being held by a hand near the gearbox.
Diagram showing the speedometer drive cable connection point on the gearbox, indicated by an arrow.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.