Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)04 · 21 Gearbox and differential
04 · Transmission

Removing-refitting (page 5 of 9)

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Removing-refitting (Automatic)
21 Gearbox and differentialRemoving-refitting · page 5 of 9
Diagram showing engine support crossbeam and adaptor installation points in the engine bay
1. Fit the engine support crossbeam 1860851000 and the special adaptor 1860851001 at the appropriate mounting points. a. Front mounting: fit the tool in the bonnet catch seating, so that it rests on the front cross member. b. Rear mounting: fit the tool level with the central reinforcement of the fire-proof bulkhead. c. Secure the cross member hook to the eye positioned previously, near the thermostat.
Diagram showing the engine support crossbeam 1860851000 installed across the engine bay
Close-up diagram of the rear mounting point of the support tool against the fire-proof bulkhead
Close-up diagram of the front mounting point of the special adaptor 1860851001 in the bonnet catch seating
Diagram showing the starter motor being moved aside after undoing its bolts
2. Remove the starter motor by undoing its bolts; then move the starter motor to one side, securing it, taking care not to damage the supply cables.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.