Alarm (page 2 of 2)

7. When a "zero" appears in the password, the button in the receiver should not be pressed, but you should wait for a new request to enter the figure indicated by the flashing.

8. After about 2 seconds the LED will emit another flash to request the input of the last figure (the 3).

9. Immediately press the button for the receiver as many times as indicated by the last digit of the password (for example: 3 times);

it should be noted that for each impulse the LED will come on briefly to give a visual confirmation.

After having entered the four figures of the password, the LED in the receiver may behave in the following way:

a) come on flashing (for 10 secs); this indicates that the Password has been entered correctly and belongs to one of the codes for the remote controls programmed;

b) come on constantly for several seconds (10 secs) to indicate that the password has not been correctly entered or that it does not correspond to any of the codes for the remote controls programmed. If this is the case, after the LED goes out, the correct password should be reintroduced starting from point 1;

• when the password has been correctly entered, the memory will be "closed".