Engine cooling radiator support beam - r r
- Make
- Fiat
- Model
- Idea Factory Service Manual
- Year
- 2003–2012
- Section
- Engine cooling › Engine cooling radiator support beam - r r
Engine cooling radiator support beam - r r
Removing
Position the vehicle on the ramp
Proceed with removal - 1048A10 air cleaner filtering element - replace
Fasten the radiator to the bodyshell.
1. Undo the bolts fixing the engine cooling radiator supporting crossmember to the wheel arch.
2. Undo the bolts fixing the engine cooling radiator supporting crossmember to the bumper.
3. Undo the bolts fixing the engine cooling radiator supporting crossmember to the bodyshell.
4. Remove the engine cooling radiator supporting crossmember after having released the rubber radiator fastenings.
Removing
Position the vehicle on the ramp
Proceed with removal
Proceed with removal - 7055A43 central front grille - r r
Proceed with removal - 7210E10 R.R. FRONT BUMPER
1. Position a hydraulic jack under the radiator lower crossmember.
Support the engine cooling radiator/air conditioning condenser assembly appropriately.
2. Undo the bolts securing the radiator bottom crossmember to the bodywork.
3. Lower the hydraulic jack and remove the lower radiator crossmember.
While lowering the hydraulic jack, check that the turbocharging air-air intercooler pins are released from the lower radiator beam.
Refitting
Place the engine cooling radiator supporting crossmember back in its housing taking care to secure the rubber fastenings to the radiator.
Tighten the bolts fixing the engine cooling radiator supporting crossmember to the bodyshell.
Tighten the bolts fixing the engine cooling radiator supporting crossmember to the bumper.
Tighten the bolts fixing the engine cooling radiator supporting crossmember to the wheel arch.
Proceed with refitting - 1048A10 air cleaner filtering element - replace.
Remove the car from the ramps.
Refitting
Using the hydraulic jack, refit the lower radiator crossmember.
Tighten the bolts securing the radiator bottom crossmember to the bodywork.
Remove the hydraulic jack from underneath the lower radiator crossmember.
Proceed with refitting - 7210E10 R.R. FRONT BUMPER.
Proceed with refitting - 7055A43 central front grille - r r.
Proceed with refitting.
Remove the car from the ramps.
Parts & tools for this job For 2003 Fiat Idea
- PARTEngine gasket setSearch: Fiat Idea 2003 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.