Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Idea Factory Service Manual (2003-2012)19 · Wiring diagrams and electrical functions
19 · Electrical

REAR FOG LAMPS - Description

Make
Fiat
Model
Idea Factory Service Manual
Year
2003–2012
Section
Interior lighting › REAR FOG LAMPS - Description
Wiring diagrams and electrical functionsREAR FOG LAMPS - Description

REAR FOG LAMPS - Description

Description

The vehicle is equipped with two bright rear fog lamps located in the rear light clusters.

The rear fog lamps are activated through the button in the control panel to the left of the steering wheel; when the lights are on the warning light in the instrument panel comes on.

The switching on of the rear fog lamp is managed by the Body Computer: it is activated in the following conditions:

  • go ahead signal with key in ON position (INT);
  • signal coming from the switch;
  • dipped headlamps or fog lights on signal.

In addition, if the dipped headlamps or the fog lights are switched off, the rear fog lamps are also switched off if the button is pressed. When the lights are switched on again, the rear fog lamps do not come back on automatically, but only if the button is pressed.

If the ignition key is switched OFF and then turned back to the ON position, the operating button must be pressed once again in order to turn the rear fog lamps back on.

The correct operation of the lights is controlled by the rear fog lamp 'check' function: the following are checked:

  • open circuit or bulb missing
  • short circuit to earth (bulb short circuit or wiring short circuit to earth)
  • short circuit to Vbatt (wiring short circuit to Vbatt)

If one of the situations described above is detected, the Body Computer notifies the CAN of the failure state: a special 'lights failure' warning light comes on in the instrument panel and, at the same time, the information is shown on the display.

Parts & tools for this job For 2003 Fiat Idea

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.