Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)02 · 10 Engine
02 · Engine

Refitting

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Engine cooling (1108) › Refitting
10 EngineRefitting

(Cont. Op. 1088C30)

  • Follow Op. 1048A28 Vacuum air circuit RESOUNDING DEVICE - R+R.
  • Follow Op. 5510C10 IGNITION COIL - R.R.
  • Unscrew the ignition coil support screw and remove.
  1. Take out the radiator upper sleeve from the thermostat group.
  2. Unscrew the screws.
  3. Remove the thermostat group (3a) and gasket (3b).
Diagram showing the removal of the radiator upper sleeve, screws, and thermostat group from the engine block

Refitting

  • Assemble the thermostat with a new gasket and fasten with its screws.
  • Insert the radiator upper sleeve on the thermostat group.
  • Assemble the ignition coils support and fasten with its screw.
  • Complete with Op. 5510C10 IGNITION COIL - R.R.
  • Complete with Op. 1048A28 Vacuum air circuit RESOUNDING DEVICE - R+R.
  • Assemble the engine compartment protection and fasten with its screws.
  • Connect the negative (-) battery terminal
NameConnector
BatteryA1
  • Fill the engine cooling system with coolant
TypeComponentNameQty
Coolant (l)ENGINE COOLANT LEVEL CHECK AND TOP UPParaflu114.0
  • Remove the body protection cover.
  • Close the engine compartment.
  • Remove the vehicle from the hoist.

1088C32 - THERMOSTAT GROUP - R+R. WITH CYLINDER HEAD REMOVED

Removal

  1. Unscrew the screws.
  2. Remove the thermostat group with the gasket.
Diagram showing the removal of the thermostat group and screws from the cylinder block with the cylinder head removed

Refitting

  • Assemble the thermostat with a new gasket and fasten with its screws.

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.