Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)02 · 10 Engine
02 · Engine

Refitting

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Engine cooling (1108) › Refitting
10 EngineRefitting

(Op. 1088D14 continued)

  1. Take out the radiator upper sleeve from the thermostat group and remove.
Diagram showing the radiator upper sleeve (1) being removed from the thermostat group

Refitting

  • Insert the radiator upper sleeve on the thermostat group.
  • Insert the upper sleeve on the radiator.
  • Insert the lower sleeve on the radiator .
  • Assemble the engine compartment protection and fasten with its screws.
  • Assemble the ignition coils support and fasten with its screw.
  • Complete with Op. 5510C10 IGNITION COIL - R+R.
  • Complete with Op. 1048A28 Vacuum air circuit RESOUNDING DEVICE - R+R.
  • Connect the negative (-) battery terminal
NameConnector
-BatteryA1
  • Fill the engine cooling system with coolant
TypeComponentNameQty
-Coolant (I)ENGINE COOLANT LEVEL CHECK AND TOP UPParaflu114.0
  • Remove the body protection cover.
  • Close the engine compartment.
  • Remove the vehicle from the hoist.

1088D26 - RIGID COOLANT INLET PIPE TO WATER PUMP - R+R. FOR VERSIONS WITH AIR CONDITIONER

Removal

  • Position the vehicle on a hoist.
  • Open the engine compartment.
  • Assemble the body protection covers.
  • Disconnect the negative (-) battery terminal.
NameConnector
-BatteryA1
  • Unscrew the engine coolant supply tank cap.
  1. Unscrew the engine compartment protection screws.
  2. Remove the engine compartment protection.
Diagram showing the engine compartment protection with screws (1, 2) being removed
Detail view of a screw (1) securing the engine compartment protection

(Cont.)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.