Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)08 · 44 Suspension and wheels
08 · Steering & suspension

Camber check

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Hubs and wheels › Camber check
44 Suspension and wheelsCamber check

(Cont.d. Op.4450A40)

Diagram showing the rear axle assembly with callout labels 1a and 1b indicating measurement points on the wheels, and a reference key 1=1a-1b

Camber check

The rear wheel camber is not adjustable. If the value measured is not within the specified limits check the suspension wishbone and the car body.

  • Carry out the preliminary checks on the car and remove any loads carried.
  • Set the car (in running order) on a lift fitted with optical inspection equipment.
  1. Check that the rear wheel camber is within the specified limits

1108 Sporting

Measure Value
1 Camber (degrees) 22'±30'

1108 Suite - 899

Measure Value
1 Camber (degrees) 42'±30'
50'±30' (*)

(*) = Car in running order but with fuel tank empty (5 litres of fuel)

Rear view diagram of the car's suspension system showing camber angle measurements at both rear wheels, indicated by callout number 1

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.