Hubs ani

HUBS ANI

Do not lubricate wheel fastening screws before assembling them: they could come loose.

• Remove the vehicle from the hoist.

4450B11 - WHEEL (ONE) REAR - R+R.

Removal

• Position the vehicle on a hoist.
• Pull the handbrake completely.
• Raise the vehicle.
• Slacken the wheel fastening screws.
• Remove the wheel cap and wheel.

Refitting

• Assemble the wheel inserting the wheel hub centering pin in one of the special holes provided on the wheel rim and tighten one of the fastening screws without locking it.
• Assemble the wheel cap and tighten the other screws without locking them.

Note: One of the wheel cap holes may be flared more; in this case, position it in correspondence with the inflating valve.

• Tighten the wheel fastening screws in cross sequence to the specified torque

Do not lubricate wheel fastening screws before assembling them: they could come loose.

• Lower the vehicle.
• Lower the handbrake lever.
• Remove the vehicle from the hoist.

4450B12 - WHEELS (TWO) FRONT - R+R.

• Refer to Op. 4450B10 WHEEL (one) front - R+R.

4450B13 - WHEELS (TWO) REAR - R+R.

• Refer to Op. 4450B11 WHEEL (one) rear - R+R.

4450B14 - WHEELS (FOUR) - R+R.

• Refer to Op. 4450B10 WHEEL (one) front - R+R.
• Refer to Op. 4450B11 WHEEL (one) rear - R+R.