Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)08 · 44 Suspension and wheels
08 · Steering & suspension

List of operations

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Hubs and wheels › List of operations
44 Suspension and wheelsList of operations
Diagram of a car showing the wheel (1) and wheel fastening screws (2)
Ref. Name
1 WHEEL
2 WHEEL FASTENING SCREWS

List of operations

Code Operation Validity
4450B10 Wheel (one) front - R+R.
4450B11 Wheel (one) rear - R+R.
4450B12 Wheels (two) front - R+R.
4450B13 Wheels (two) rear - R+R.
4450B14 Wheels (four) - R+R.

OPERATIONS

4450B10 - WHEEL (ONE) FRONT - R+R.

Removal

  • Position the vehicle on a hoist.
  • With the wheel resting on the ground, slacken the wheel fastening screws.

Note: It is not necessary to slacken the wheel fastening screws if pneumatic equipment is available.

  • Raise the vehicle.
  • Slacken the wheel fastening screws.
  • Remove the wheel cap and wheel.

Refitting

  • Assemble the wheel, inserting the wheel hub centering pin in one of the special holes provided on the wheel rim and tighten one of the fastening screws without locking it.
  • Assemble the wheel cap and tighten the other screws without locking them.

Note: One of the wheel cap holes may be flared more; in this case, position it in correspondence with the inflating valve.

  • Lower the vehicle.
  • With the wheel resting on the ground, tighten the wheel fastening screws in cross sequence to the specified torque
Fastening Component Ø Value (daNm)
- Screw WHEEL M12 8.6

Note: If pneumatic equipment is available, it is possible to tighten the wheel fastening screws to the specified torque in cross sequence with the wheel raised.

(Cont.d)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.