899

Beware of electric arcs. Although the battery voltage is 12V, the battery can output high currents in the event of a short circuit. This can cause arcs or sparks which can be dangerous to the operator or could be the cause of fire.

Beware of high voltage. The electronic ignition system can generate voltages of 20,000V or more. This can be extremely dangerous. Work with extreme caution on or near components.

Beware of fire. Never smoke when working near the battery or components subject to heating during operation (e.g. halogen lights) nor in the engine compartment when the engine is warm. Avoid burns or damage to tools and components.

899

5540C14 - HEADLIGHT BEAM ADJUSTMENT MANUAL HYDRAULIC DEVICE - R.R.

Removal

1. Release the actuator from the mechanism by means of the lever (right-hand front headlight).
2. Turn the actuator clockwise and remove it from its seat.

• Remove the air cleaner cover (see Op. 1048A10 - COMPLETE AIR CLEANER - R.R.).
• Release the actuator pipe from the five fastenings along the front crossmember.

1. Remove the three fastening screws and shift the injection ECU and bracket to the side to facilitate removal.

• To access the left-hand hydraulic actuator, remove the headlight (see Op. 5540B10 - HEADLIGHT, LH or RH - r.r.) and proceed as for the right-hand actuator.
• Release the actuator hydraulic pipes from the three plastic fastenings on the front left-hand strut.
• Disconnect the bonnet lock opening device wire (see Op. 7025A26 - BONNET LOCK OPENING DEVICE CONTROL - r.r.).

1. Disconnect the rear window washer pipe (1a) from the fitting (1b) near the bonnet lock.

To facilitate removal, disassemble the climate control unit panelling.

• Remove the climate control group bulkhead.

(Cont..)