Refitting

(Op. 5540C14 continued)

• Remove the climate control group bulkhead seal.

1. Remove the hydraulic headlight beam adjuster device knob.
2. Using tool (2a) as a lever, remove tab (2b).

1. Remove the two fastening screws from the dashboard panel.

• Release the two pipes from the clip near the steering control support.

1. From inside the vehicle, pull and remove the bonnet lock opening device wire (1a) and the rear window washer pipe (1b) from the chock pad.
2. With a screwdriver, push the chock pad into the passenger compartment.

• Take the two actuators and pipes into the passenger compartment.

1. It is now possible to remove the whole hydraulic device for the manual adjustment of the headlight positioning from the car body.

Refitting

• Reposition the actuators, the bonnet lock opening device wire and the rear window washer pipe in their respective seat in the chock pad and insert them through the wall into the engine compartment.

(Cont..)