S25 Clutch noise
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Noise and vibration › S25 Clutch noise
DiagnosisS25 Clutch noise
S25 Clutch noise
Noise is noted when operating the clutch pedal.
– With the engine on and handbrake engaged, engage first gear and release the clutch. If the noise ceases, it may be caused by parts other than the clutch, see Diagnosis S40
| Step | Validity | Operation to be performed | Test results | ||
|---|---|---|---|---|---|
| OK | ⚠ | 🔧 | |||
| 1 | CHECK CLUTCH | All OK | Problems found | Intervention | |
| Check: – clutch plate worn or damaged – clutch spring drive damaged – pressure plate spring diaphragm damaged – bearing damaged |
Go to Step 2 | Faulty clutch plate or pressure plate | Replace clutch plate PROCEDURE OP. 1810A20 If oil or grease is found, also replace the gearbox inlet oil seal PROCEDURE OP. 2110C20 |
||
| Faulty bearing | Replace bearing PROCEDURE OP. 1810A30 |
||||
| 2 | CHECK CORRECT OPERATION | All OK | Problems found | Intervention | |
| Check the fault is no longer present | End of test | Fault persists | Seek the fault starting from another symptom, e.g. gearbox noise source, see table S20 | ||
Parts & tools for this job For 1998 Fiat Seicento
- PARTClutch kitSearch: Fiat Seicento 1998 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Fiat Seicento manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.